Rear Panel Controls And Connectors; Lto Tape Cartridges; Environmental And Shipping Information; Figure 1-2 Lto Standalone Rear Panel - ADIC LTO 200D User Manual

Rear Panel Controls and Connectors

Figure 1-2 shows the controls and connectors located on the rear panel of the LTO standalone.
AC Power Connector
SCSI Connectors

Table 1-2 Rear Panel Controls and Connectors

Control or Connector
Power Switch
AC Power Connector
SCSI Connectors
SCSI ID Switch

LTO Tape Cartridges

To ensure that your LTO standalone conforms to ADIC specifications for reliability, use industry-approved LTO Ultrium tape cartridges.
Other certified LTO Ultrium data cartridges supported by your LTO standalone include: 10GB, 30GB, and 50GB.

Environmental and Shipping Information

Whenever possible, store LTO Ultrium Tape Cartridges in the following room-environment conditions:
Temperature of 20°C, to 5°C (68°F, to 9°F)
Relative humidity of 50% (20%)

Figure 1-2 LTO Standalone Rear Panel

Purpose
Turns power to the unit on and off.
Receptacle for AC power cord.
Connections for the interface cable that connects the unit with the host computer
and/or to other devices on the SCSI channel. The interface cable can be attached
to either connector.
Your LTO standalone is equipped with a 68-pin high density SCSI device
connector.
Used to select the SCSI ID for the LTO drive. Factory set at 0.
SCSI ID Switch
Power Switch
Introduction 5