Set Up And Operation; Installation Of The Lamp - SHOWTEC Blacklight 400W Manual

Blacklight 400W

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.

Installation of the lamp

Follow the steps below to insert the Blacklight 400W E40 discharge lamp into the housing.
01) Remove the 4 screws and remove the front cover.
02) Insert the E40 lamp (82485) into the housing.
03) Replace the cover and tighten the 4 screws.
04) Connect the power supply.
Fig. 03
Ordercode: 80319
9