13- - - - 5 Adjusting the spreaders
13
13
13
5 Adjusting the spreaders
5 Adjusting the spreaders
5 Adjusting the spreaders
The clearance between spreader K,L and M and needles should be 1~1.2mm.
Spreader up-and-down adjustment is made with screws Q.
Spreader tilt adjustment is made with screws R.
【14】PTV MECHANISM
14
14- - - - 1 Disassembling and reassembling the binder
1 Disassembling and reassembling the binder
14
14
1 Disassembling and reassembling the binder
1 Disassembling and reassembling the binder
■ T o disassemble the binder
Remove screw A. Remove the binder by pulling it
toward you while referring to arrows B and C.
< Note >
When removing the binder, be careful not to damage
the ends of the fabric guides.
■ T o reassemble the binder
Fit the ends of upper fabric guides (F) onto lower
fabric guides (G).
direction of arrow H.
screw touches the bracket. Then tighten screw A.
Move the binder down in the
Check that end D of the
22