Adjusting The Binder Up And Down; Position Of The Upper And Lower Fingers Of The Binder; Cleaning The Machine - KANSAI SPECIAL BX Series Instructions Manual

14- - - - 2 Adjusting the binder up and down

14 14 14 2 Adjusting the binder up and down 2 Adjusting the binder up and down 2 Adjusting the binder up and down
Adjust the binder up and down according to the
fabric to be used. Adjustment is made by loosening
screw A and wing screw I and turning screw D as
required.
After this adjustment is made, tighten screw A and
wing screw I.
< Note >
Adjust the position of J and K according to the
finished pin tuck.
14

14- - - - 3 Position of the upper and lower fingers of the binder

3 Position of the upper and lower fingers of the binder
14 14 3 Position of the upper and lower fingers of the binder 3 Position of the upper and lower fingers of the binder
Position upper and lower fingers so that distance A
is halved by each vertical center line of the needles.
The line formed by the points of the upper and lower
fingers should be parallel with each horizontal
center line of the needles.
【15】CLEANING THE MACHINE
At the end of each day, remove the presser foot
and the needle plate and then clean the slots
of the needle plate and the area around the
feed dogs.
23