Table 5. Network Settings Page - Certance CP3100 D2D2T User Manual

Quantum cp3100 d2d2t: user guide

Hide thumbs Also See for CP3100 D2D2T:

Table of Contents

Initial Setup

Table 5. Network Settings Page

Value

Host Name

IP Address

Network Mask

Default Gateway

Configuring Email Settings

The Email Settings page lets you configure RemoteAdmin to send email notifications when Attentions

occur. When the CP 3100 sends an email about an Attention, the message identifies the CP 3100

by the host name you configured above and includes a description of the Attention condition.

NOTE: Typically, your system administrator will provide you with these settings. If not, check

with your system administrator before selecting these values.

Click CONFIGURATION, then click EMAIL. The Email Settings page appears (see

Figure 25 on page 51).

Description

The host name that uniquely identifies the CP 3100. This value is optional and

defaults to the CP 3100's MAC address. However, it can be any descriptive text

you want.

The IP address that uniquely identifies the CP 3100 (up to four octets from 0 to

255, separated by periods). You enter this IP address in your browser to launch

RemoteAdmin. Default is: 192.168.0.250. The RemoteAdmin user must be on the

same subnet as the CP 3100. Be sure no other device on the subnet has this IP

address.

The CP 3100 network mask, (up to four octets from 0 to 255, separated by peri-

ods). This value must match the network mask used by the subnet. Default is:

255.255.255.0

The IP address of the default gateway (up to four octets from 0 to 255, separated

by periods). This value is required if RemoteAdmin is to send email notifications.

Default is: 192.168.0.1

Setting the Initial Configuration

Table of Contents

Table of Contents