Installing The Internal Cp 3100 - Certance CP3100 D2D2T User Manual

Quantum cp3100 d2d2t: user guide

Hide thumbs Also See for CP3100 D2D2T:

Table of Contents

Installing the CP 3100

Installing the Internal CP 3100

To install the CP 3100 in your computer:

Shut down the computer as you would normally. Then turn off all peripherals connected to it.

Disconnect the computer's AC power cord.

Remove the computer cover to gain access to the inside of the computer. The documentation

that came with your computer should explain this procedure.

NOTE. If you disconnect cables to gain access to the mounting bay, note which cables were

removed. You can then refer to this information when you reconnect the cables at the end of this

procedure.

Select an available 5.25-inch, half-height mounting bay and remove the front panel

Install the CP 3100 in the mounting bay by sliding the unit through the front of the computer

(see Figure 4 on page 25).

Figure 4. Installing the CP 3100

Installing an Internal CP 3100

Table of Contents

Table of Contents