Installing the CP 3100
Figure 19. Back Panel of the Desktop CP 3100
NOTE. The following connectors on the back panel of the desktop CP 3100 are not used:
• Archive Network (Gbe2)
• Serial
Connecting to a Host
To connect the desktop CP 3100 to a host computer, use the following procedure.
1.
Shut down the host computer and disconnect the computer's AC power cord.
2.
Connect an LVD Male HD68 SCSI cable to the SCSI IN connector on the back panel of the
desktop CP 3100 (see Figure 19 on page 37).
3.
Connect the other end of the cable to the computer.
Connecting to a Tape Drive
If you purchased the CP3100D-160, connect the unit to an approved DDS-4 or DAT 72 tape archive
device.
1.
Connect an LVD Male HD68 SCSI cable to the ARCHIVE SCSI connector on the back panel
of the desktop CP 3100 (see Figure 19 on page 37).
2.
Connect the other end of the cable to your tape drive.
Installing a Desktop CP 3100
37