Figure 22. Date/Time Settings Page - Certance CP3100 D2D2T User Manual

Quantum cp3100 d2d2t: user guide

Hide thumbs Also See for CP3100 D2D2T:

Table of Contents

Initial Setup

Setting the CP 3100's Internal Clock

The CP 3100 has an internal clock that tracks the current date and time. This clock is turned off when

the CP 3100 is shipped. You must set the clock before you use the CP 3100.

NOTE: Do not change the date or time when the CP 3100 is reading from or writing to virtual or

physical tape cartridges.

Click CONFIGURATION. The Date/Time Settings page appears (see Figure 22 on

page 46).

Figure 22. Date/Time Settings Page

Enter the information described in the Date/Time Settings page (see Table 3 on page 47).

Click Update. A message confirms that the date and time have been updated.

NOTE: The Date/Time Settings page has a Reset button you can click to cancel your changes.

If you enter the date and/or time using the wrong format, an error message appears showing

the correct format to use. If this happens, click the Back button in your Browser and enter the

appropriate date or time.

Setting the Initial Configuration

Table of Contents

Table of Contents