Table 4. Password Settings Page - Certance CP3100 D2D2T User Manual

Initial Setup
2. Enter the information described in the Password Settings page (see Table 4 on page 48).
3. Click Update. A message confirms that the user password has been updated.
Record the password in Chapter 10.
4.
NOTE: The Password Settings page has a Reset button you can click to cancel your changes.

Table 4. Password Settings Page

Value
Old Password
New Password
Confirm Password
Configuring Network Settings
The CP 3100 comes with a pre-configured IP address. When you log into RemoteAdmin for the first
time, you will most likely need to change the default IP address to suit the requirements of your net-
work. As part of this procedure, you can also specify the CP 3100 host name, network mask, and
default gateway.
NOTE: Typically, your system administrator will provide you with these settings. If not, check
with your system administrator before selecting these values.
1. Click CONFIGURATION, then click NETWORK. The Network Settings page appears (see
Figure 24 on page 49).
Description
Your current password. For first-time login, leave this blank.
The new password you want to use. The password is case-sensitive. For security
purposes, each password character appears as an asterisk (*).
The same password you typed for New Password. For security purposes, each
password character appears as an asterisk (*). If this password does not match
the New Password, an error message appears and the password is not changed.
Setting the Initial Configuration
48