Certance CP3100 D2D2T User Manual page 38

Installing the CP 3100
If the integrated hard disk has not been initialized, the CP 3100 prepares the disk for use. This
•
can take from 3 to 5 minutes.
The CP 3100 loads the current configuration settings, initializes the network interface, starts
•
the device emulation, and activates its RemoteAdmin management tool.
The System LED turns solid green.
•
NOTE. In the unlikely event you encounter a problem at power-up, refer to Chapter 9 for trouble-
shooting suggestions.
Installing the Driver
For information about installing the driver, see "Installing the Driver" on page 31.
Registering the CP 3100
After you install the CP 3100, be sure to register it. Registering it ensures that you will receive the lat-
est information about the CP 3100, as well as other product, service, and support information. For
your convenience, you can register the CP 3100 through our Web site at:
http://register.certance.com.
How to Proceed
After you install the CP 3100, proceed to Chapter 4 to continue with the initial setup of the desktop
CP 3100. After you perform the initial setup and verify your installation, you can refer to:
Chapter 5 to use the RemoteAdmin tool to perform basic and advanced operations.
•
Chapter 7 to learn about the CP 3100 LEDs.
•
Chapter 8 for information about using the CP 3100 integrated tape drive.
•
Installing a Desktop CP 3100
39