Certance CP3100 D2D2T User Manual page 42

Installing the CP 3100
Powering-up the Rack-Mount CP 3100
To power-up the rack-mount CP 3100:
Re-attach the computer's AC power cord, then turn on the computer.
1.
2. Attach the power cord securely to the power connector on the CP 3100 (see Figure 20 on
page 41).
3. Set the Power switch on the back panel to the ON position. Facing the back of the CP 3100,
the Power button is located to the right of the power connector (see Figure 19 on page 37).
4. Wait 2 minutes (up to 5 minutes on first use) for the drive to initialize, then turn on the host.
When the CP 3100 is started for the first time, the following events should occur:
The CP 3100 boots and turns on four LEDS, one at a time, from bottom to top; then it turns off
•
the four LEDs in the same way. All LEDs will be off for a short period of time. When the
CP 3100 boots successfully, the topmost LED turns on.
If the integrated hard disk has not been initialized, the CP 3100 prepares the disk for use. This
•
can take from 3 to 5 minutes.
The CP 3100 loads the current configuration settings, initializes the network interface, starts
•
the device emulation, and activates its RemoteAdmin management tool.
The System LED turns solid green.
•
NOTE. In the unlikely event you encounter a problem at power-up, refer to Chapter 9 for trouble-
shooting suggestions.
Installing the Driver
For information about installing the driver, see "Installing the Driver" on page 31.
Registering the CP 3100
After you install the CP 3100, be sure to register it. Registering it ensures that you will receive the lat-
est information about the CP 3100, as well as other product, service, and support information. For
your convenience, you can register the CP 3100 through our Web site at:
http://register.certance.com.
How to Proceed
After you install the CP 3100, proceed to Chapter 4 to continue with the initial setup of the rack-
mount CP 3100. After you perform the initial setup and verify your installation, you can refer to:
Chapter 5 to use the RemoteAdmin tool to perform basic and advanced operations.
•
Chapter 7 to learn about the CP 3100 LEDs.
•
Chapter 8 for information about using the CP 3100 integrated tape drive.
•
Installing the Rack-Mount CP 3100
43