Enabling Wireless Headset Bidirectional Signaling; Setting Headset Mic Level - Avaya J189 Manual

Customization

Enabling wireless headset bidirectional signaling

Before you begin
Check if the headset supports electronic hook switch (EHS) signaling.
Note:
Headset Signaling setting is used to configure only DECT headsets and cannot be applied to
Bluetooth headsets.
Procedure
1. Press Main menu.
2. Scroll to Settings, and press Select.
3. Scroll to Audio settings, and press Select.
4. Scroll to Headset signaling.
5. Press Toggle to select one of the following options:
• Disabled: Disables signaling from the phone to the headset.
• Switch hook and alert: Activates the link to the headset if you press Headset. When
the phone receives an incoming call, you hear the alert tone in the headset.
• Switch hook only: Activates the link to the headset if you press Headset. When the
phone receives an incoming call, you do not hear the alert tone in the headset.
6. Press Save.

Setting headset mic level

About this task
Use this procedure to adjust the best headset performance.
Before you begin
• Ensure that you are on a call and the caller's audio level is at 50%.
• Adjust the microphone position as recommended by your headset vendor.
Procedure
1. Press Main menu.
2. Scroll to Settings, and press Select.
3. Scroll to Audio settings, and press Select.
4. Scroll to Headset mic level, and press Select.
August 2020 Using Avaya J189 IP Phone SIP
Comments on this document? infodev@avaya.com
110