Removal & Re-Fitting The Trim / Fret; User Replaceable Parts - Flavel Linear HE Installation, Maintenance & User Instructions

6.14 REMOVAL AND RE-FITTING THE TRIMS / FRETS
Models supplied with one piece trim & fret / ashpan cover
6.14.1 Fit the outer trim assembly to the firebox with the magnets
provided.
6.14.2 Remove the fret & ashpan cover from the packaging.
Place fret up to the front radiused burner heat shield .
6.14.3 Place ashpan cover under fret assembly and centralise.
Models supplied with fascia's
6.14.4 Refer to the fitting instructions supplied with the fascia for advice on
removal / re-fitting.
NOTE : Some models in this range are not supplied with a fret from the
factory, therefore please consult your local retailer for fitting
advice on the type of fret supplied with these models.
6.15

USER REPLACEABLE PARTS

The only user replaceable parts on this fire are the glass panel, fuelbed
components and coals / pebbles which may be replaced as described in section
6.9/6.10. In order to replace the fuel-bed components, the glass panel of the
appliance will need to be removed, please refer to pages 86 & 87 of this book for
details on how to remove the glass panel.
Replacement of any other parts must be carried out by a competent person such
as a registered gas installer. The part numbers of the user replaceable parts are
as follows, these are available from BFM Europe Ltd. who may be
contacted at the number on the rear cover of this book.
Complete pebble / ceramic set
Pebble fuelbed base
Pebble fuelbed front rail
Replacement pebble set
Complete coal / ceramic set
Coal fuelbed base
Coal fuelbed front rail
Replacement coal set
Glass panel
88
/ FASCIA'S
B-110000
B-108050
B-105060
B-110020
B-121600
B-121550
B-121560
B-121610
B-125630