Table of Contents
Advertisement
6.13
REMOVAL AND RE-FITTING THE TRIMS / FRETS
Models supplied with one piece cast trim
6.13.1
Fit the fascia to the firebox by hooking the mounting brackets into the
slots on the firebox.
Removal / re-fitting of the contemporary fret & ashpan cover
6.13.2
The fret retaining brackets hook over the burner heat shield brackets.
6.13.3
Place ashpan cover under fret assembly and centralise.
Removal / re-fitting of the traditional fret & ashpan cover
6.13.4
Remove the fret & ashpan cover from the packaging.
6.13.5
Place fret up to the front radiused burner heat shield
6.13.6
Place ashpan cover under fret assembly and centralise.
6.14
USER REPLACEABLE PARTS
The only user replaceable parts on this fire are the fuelbed components and
coals which may be replaced as described in section 6.9. In order to replace the
fuel-bed components, the glass panel of the appliance will need to be removed,
please refer to pages 77 & 78 of this book for details on how to remove the glass
panel.
Replacement of any other parts must be carried out by a competent person such
as a registered gas installer. The part numbers of the user replaceable parts are
as follows, these are available from BFM Europe Ltd. who may be contacted at the
number on the rear cover of this book.
Complete coal / ceramic set
Fuelbed base
Fuelbed front rail
Replacement coal set
Replacement glass panel
B-105190
B-105070
B-126490
B-105180
B-125640
81
Advertisement
Table of Contents
