Lighting The Appliance (Manual Control Model) - Flavel Linear HE Installation, Maintenance & User Instructions

Warning : Use only the pebbles supplied with the fire. When replacing the
pebbles remove the old pebbles and discard them. Fit a complete
set of pebbles of the correct type. Do not fit additional pebbles or
any pebbles other than a genuine replacement set.
To ensure that the release of fibres from these R.C.F (Refractory Ceramic
Fibre) articles is kept to a minimum, during installation and servicing we
recommend that you use a HEPA filtered vacuum to remove any dust
accumulated in and around the appliance before and after working on the
appliance. When replacing these articles we recommend that the replaced
items are not broken up, but are sealed within heavy duty polythene bags,
clearly labelled as "RCF waste". RCF waste is classed as a "stable", non
reactive hazardous waste and may be disposed of at a landfill licensed to
accept such waste Protective clothing is not required when handling these
articles, but we recommend you follow the normal hygiene rules of not
smoking, eating or drinking in the work area, and always wash your hands
before eating or drinking.
3.2.7 Replace the glass panel and retaining trims as described on
pages 11 & 12.
NEVER USE THE FIRE WITHOUT THE GLASS PANEL IN POSITION, OR IF
BROKEN OR CRACKED.
3.3 LIGHTING THE APPLIANCE (MANUAL CONTROL MODELS)
3.3.1 Turn on the gas isolation tap.
3.3.2 Depress the control knob and turn anti-clockwise to the position
marked pilot. Hold in the control knob for a few seconds to purge the
pipe work.
3.3.3 Continue to hold-in the control knob and press the igniter button. If the
burner does not light, continue to press the igniter button until ignition
occurs. Continue to hold the control knob for 5-10 seconds to allow the
thermocouple to heat up, if the pilot goes out when the control knob is
released, repeat the lighting sequence.
3.3.4 Turn the control knob in the anti-clockwise direction to the high position
and the main burner will light. Keep the control knob in the high
position for approximately. 10 mins until the fire has warmed up, then
adjust as necessary.
3.3.5 Turn the control knob clockwise to the low position and the gas input
will be reduced to the minimum setting.
30