Table of Contents
Advertisement
3.9.2.4
If at any time the power button is operated during thermostat mode the
control will cancel any thermostat operation and return the control to
manual mode.
3.9.2.5
IMPORTANT NOTE : Thermostat mode will not light the fire
automatically and will only regulate between the maximum and
minimum burner setting. The fire must be lit manually via the
handset and then you enter thermostat mode as described in this
section and set the temperature. When no longer requiring
thermostat mode turn off the burner and the handset will return to
manual mode.
3.10
FITTING THE TRIMS & FRETS OR FASCIA'S
Models supplied with one piece trim & fret / ashpan cover (Kenilworth
models)
3.10.1
Fit the outer trim assembly to the firebox with the magnets
provided.
3.10.2
Remove the fret & ashpan cover from the packaging.
Place fret up to the front radiused burner heat shield .
3.10.3
Place ashpan cover under fret assembly and centralise.
Models supplied with fascia's (Linear models)
3.10.4
Refer to the fitting instructions supplied with the fascia for advice on
removal / re-fitting.
NOTE :
Some models in this range are not supplied with a fret from the
factory, therefore please consult your local retailer for fitting
advice on the type of fret supplied with these models.
Models supplied with one piece HITW fascia's (Diamond & Expression
models)
3.10.5
Hook the fascia onto the top mounting bracket fitted to the firebox.
3.10.6
The bottom of the fascia is retained by magnets fitted to the lower
retaining brackets.
45
Hide quick links:
Advertisement
Table of Contents
