Table of Contents
Advertisement
2.5
FITTING OF THE FRET AND SIDE CHEEKS
a)
For this part of the installation, the latex gloves supplied should be used
to protect the decorative parts. Also, leave the protective coating in
place until the installation is complete.
b)
Remove the two off M4 nuts and washers on the base of the firebox, as
shown below in Fig. 8a
c)
Fit the lower canopy to the firebox by locating the two holes in the lower
canopy onto the two studs as detailed in section b) above and refitting
the two off M4 nuts and washers on the base of the firebox
d)
Locate the three studs in the upper canopy onto the three protruding
flanges at the top of the firebox. Once located, the inner flange on the
lower surface can be secured using the M4 nuts and bolts supplied.
Finally, using an M3 nut runner or socket and the M3 nuts supplied
secure the canopy through the holes in the lower surface.
e)
Remove the protective cover from the upper surface of the lower
canopy and that on the flanges of the fret only.
f)
Fit the fret, located by two M5 screws in the holes provided.
g)
Remove the protective covering from the side cheeks and fit as shown
in Fig. 8b overpage.
Fig. 8a
Position of M4 Nuts & washers on base of firebox
Lower canopy locates onto these weld studs
12
Hide quick links:
Advertisement
Table of Contents
