Table of Contents
Advertisement
3.2
FITTING THE TRIM (ORA / ALUMA MODELS)
a)
Refitting the trim is achieved by locating the rear flange of the trim over
the flange on the firebox mounting face, then replacing the screws at
the L/H and R/H bottom of the trim.
3.3
FITTING THE TRIM (TOCCATA MODELS)
a)
Fit the two side pieces of the trim by overlapping the lips of the trim
over the side lip of the firebox.
b)
Fit the top piece of the trim by overlapping the lips of the trim over the
lip of the firebox and over the two side trims.
3.4
TO FIT THE FENDER (ALL MODELS)
a)
Attach L/H & R/H Brackets to fender with M6 pozi screws which locate
onto the burner retaining brackets at each end of the burner assembly.
See fig. 17, 18 & 19.
Fig. 17
Fret location slots in
firebox
Fig. 18
Locating slots in fender
brackets. Locate these
slots onto firebox
retaining slots as shown
in Fig. 8 above
21
- Quick Links:
- Assembling the Ceramics and Fuel Bed
Hide quick links:
Advertisement
Table of Contents
