Table of Contents
Advertisement
Operating Manual
4.5.1
4.5.2
4.6
20439 / 03.04 / 03 / engl.
Charging The AkuPak With The Plug-In Power Pack
1 Power plug
3 socket at AkuPak
5 Marking"red dot"
Illustration 15
The AkuPak must be put into the device.
Turn the connector (2) on the charging cable of the plug-in power pack (1) so
that its red dot is in line (5) with the red dot on the socket (3) of the AkuPak (4).
Push in the connector (2) into the socket until it can go no further.
Connect the plug-in power pack with the plug (6) into a socket.
The accumulator begins to charge automatically if the remaining power in the
AkuPak is less than 30 percent of its nominal capacity. The AkuPak is charging if
the LED on the charging device lights up. The time required for charging is around
one hour.
Nickel-cadmium accumulators are subject to natural wear and tear and should be re-
placed at least every two years if the usage is high.
Charging The AkuPak In The Optional Wall Mount Rack
Refer to the separate operating manual of the Wall Mount Rack for this.
Connecting The Power Pack (PowerLine) (Optional Accessory)
Insert the power pack plug in a socket near the patient. The power cable is around
three metres long.
HeartSave AED / AED-M
2 plug
4 AkuPak
6 plug
21
Advertisement
Table of Contents
