Connecting The Drain Hose To The; Adjusting The Stands - Beko B3D59644UG User Manual

b. Tighten all hose nuts by hand. Never use
a tool when tightening the nuts.
c. Open the taps completely after making
the hose connection to check for water
leaks at the connection points. If any leak
occurs, turn off the tap and remove the
nut. Check the gasket and tighten the nut
carefully again. In order to prevent the
water leaks and resultant damages, keep
the taps closed when you do not use the
product.
4.5 Connecting the Drain Hose to
the Drain
a. Attach the end of the drain hose directly
to waste water drain, washbasin or
bathtub.
Your house will be flooded if the wa-
ter draining hose is dislocated during
water draining. There is also a risk of
burning due to the high washing
temperatures. In order to prevent
such situations and make sure that
the product performs water intake
and drain processes without any
problem, fix the drain hose securely.
b. Connect the hose to a minimum height of
40 cm and a maximum height of 90 cm.
c. If the hose is placed on the floor (or at a
maximum height of 40 cm from the floor)
and then its height is increased, dischar-
ging of water becomes difficult, and laun-
dry may come out very wet from the ma-
chine. Thus, follow the heights provided
in the figure.
d. To prevent the waste water to go back
into the product again and to ensure easy
drainage, do not immerse the end of the
hose into the waste water or do not insert
it into the drain for more than 15 cm. If it
is too long, cut it short.
e. The end of the hose should not be bent,
it should not be stepped on and the hose
must not be pinched between the drain
and the product. Otherwise, water dis-
charge issues may emerge.
f. If the length of the hose is too short, use
it by adding an original extension hose.
The overall length of the hose shall not be
longer than 3.2 m. To prevent water
leaks, always secure the connection
between the extension hose and the
draining hose of the product with a suit-
able clamp so that it does not come off
and cause leaks.

4.6 Adjusting the Stands

WARNING
In order to ensure that the product
operates more silently and vibration-
free, it must stand level and bal-
anced on its feet. Ensure that the
product is balanced by adjusting the
feet. Otherwise, the product may
move from its place and cause
crushing, noise and vibration prob-
lems.
To avoid damaging the lock nuts, do
not use any tools to loosen the nuts.
a. Loosen the lock nuts on the feet by hand.
b. Adjust the feet until the product stands
level and balanced.
c. Tighten all lock nuts again by hand.
EN / 16