Table of Contents
Advertisement
Section 5: Slideout Systems
MAJOR and MINOR faults; faults must be cleared for the room to operate normally.
MINOR faults can be cleared by pushing and releasing the IN or OUT buttons
on the wall touchpad.
MAJOR faults must be cleared by pushing and releasing the SET STOPS/CLEAR
FAULTS button located on the back of the wall touchpad.
™ NOTE: For MAJOR faults, the control must be overridden by following the
EMERGENCY RETRACT MODE in the OVERRIDE MODES section.
Fault Codes
F a u l t
F a u l t
Code
Type
Description
Stops not
1
Major
programmed
2
Minor
System Fault
Excessive
4
Major
Battery
Voltage
Park brake LED flashing
6
Minor
64
Possible Cause
-Stops have not been
set
-Stops were cleared
-Stops were improperly
set
-Obstruction present
-Excessive system drag
-Bad or loose connec-
tion
-Defective harness
-Open or shorted motor
-Parking brake not set
(if applicable)
-Ground signal lost at
park brake control
Supply voltage to
control box is 17 0 V DC
or greater
Table of Contents
Possible Solution
Steps need to be pro-
grammed by an authorized
service facility.
Run room in opposite direc-
tion. If it continues to move
in the opposite direction,
remove obstruction, exces-
sive weight in room or repair
of damaged component. If
room stops moving in oppo-
site direction, observe fault
code and refer to this chart
-Check all connections at
control box and motor.
-Check the harness for bro-
ken wires.
-Put 12.0 VDC direct to the
motor. If it does not run,
replace the motor.
-Set parking brake (if ap-
plicable)
-Check for continuity to
ground on wire plugged
into park brake connector at
control box.
Check 2-pin power connector
at control box. If the voltage
is 17. VDC or higher, contact
O.E.M for power and ground
supplies
Advertisement
Table of Contents
