Table of Contents
Advertisement
Section 6: Electrical System
Kitchen and bath vents and vent covers
Door locks
TV, radio and DVD systems
Automatic fireplace control
Lowering/raising the automatic ramp door (toy hauler)
RVMaster Switches (remote controls)
The system will come with multiple individual smart remote controls (or RVMaster Switch-
es). Depending on your floorplan or system, these can be programmed for individual room
control. The remotes are installed on the wall in each room.
Pairing the remote controls
Remote controls come from the factory paired to your system. If remotes get "un-paired"
from the RV Bluetooth system, press the arrow keys at the bottom of the touchscreen until
PA appears in the Menu Display. Press the RET button and the display will blink on and
off indicating the system is ready for pairing. Press and hold any two buttons on the remote
control. The PA display will go out when pairing is complete. The remote will now be able
to operate the systems labeled on the individual buttons for that specific room and remote.
Remote Batteries
The RVMaster Switch remote controls use a 3V Lithium CR2032 coin cell battery.
To access the battery on the back of the remote, remove the remote from the wall:
Pull the bottom of the remote away from the wall. There will be an audible snap
as it releases from the clip.
Lift the remote upwards to unhook it at the top.
The remote will separate from the wall mount.
To replace the remote on the wall:
Hook the top of the remote on the top of the wall bracket.
Push the bottom of the remote back in place. There will be an audible snap as as
it attaches to the mount.
Touchscreen Control Panel
The row of buttons at the bottom of the touchscreen control certain pre-programmed fea-
tures and allow control of the slideouts, awnings, lights and water pump. In the event the
touchscreen is not working, this Control Panel will allow manual operation separate from
the touchscreen.
™ NOTE: Buttons #1 through #4 are pre-programmed from the factory and
cannot be changed to perform other functions.
Button #1 – Turns all interior lights ON or OFF. Press once for ON, press again
for OFF.
Button #2 – Turns all outside lights ON or OFF, which include security lights,
awning lights, and ramp door lights (toy hauler). It does not operate the front cap
LED lights. Press once for ON, press again for OFF.
Button #3 – Turns inside and outside lights ON or OFF. Press once for ON, press
again for OFF.
Button #4 – Turns water pump ON or OFF. Press once for ON, press again for
OFF.
Arrow Buttons – Used to select awnings or slideouts, pair your smart phone
or tablet to the touchscreen system, pairing the dedicated remotes, or to turn the
touchscreen display OFF.
RESET Button - There is a small pinhole above the left arrow on the Menu Dis-
play that will reset the touchscreen.
72
Table of Contents
Advertisement
Table of Contents
