Table of Contents
Advertisement
Section 2: Occupant Safety
When the battery is removed from the alarm, the battery flag will pop up; the alarm cannot
be installed to the mounting bracket without a battery.
To test, stand at arm's length from the smoke alarm as the
alarm horn is loud and may be harmful to your hearing.
The test button will accurately test all functions. Never use
an open flame to test the smoke alarm.
Do not remove the warning label located near the smoke
alarm from your recreation vehicle:
Key Features:
•
Silence Feature: Silences nuisance alarms
•
Hinged cover allows for easy battery replacement
•
Lighted Power and Alarm Indicator. LED indicates battery is connected.
•
Test/Silence button – One touch button combines both features
•
Low Battery indicator – Beeping signal indicates low battery.
Maintenance
Vacuum off any dust on the cover of the smoke alarm using a soft brush attachment. Test the
smoke alarm once you have vacuumed. Never use water, cleaners or solvents to clean the
smoke alarm as they may damage the alarm. Do not paint the smoke alarm.
Refer to and follow detailed safety, testing, troubleshooting and maintenance information
found in the manufacturer's user pamphlet located in your warranty packet.
Combination Carbon Monoxide /Propane Alarm
Your recreation vehicle is equipped with a combination
carbon monoxide (CO) / propane alarm that is listed
for use in recreation vehicles. The combination carbon
monoxide/propane alarm will only work if it is opera-
tional and maintained.
The alarm is directly wired to the 12-volt electrical
system, with continuous power being supplied by the
recreational vehicle batteries. There is no battery power
supply. As a result, the alarm is always drawing a small
amount of current from the recreation vehicle batteries.
Although the current draw is slight, it could drain the
batteries during extended storage periods. This condi-
tion is not likely to occur except during storage situa-
tions when the inverter cannot restore the battery charge. If the battery cable is discon-
nected at the battery terminals, the combination alarm will not work.
Be sure to read, understand and follow the owner's information from the manufacturer of
the combination CO/propane alarm. This includes information regarding the limited life of
the alarm.
20
Table of Contents
Advertisement
Table of Contents
