Table of Contents
Advertisement
Section 8: Plumbing System
A check valve is located inside the city water connection inlet on the utility
center. NEVER depress the check valve on the "CITY WATER CON-
NECTION" inlet with pressure in the line. It will cause irreparable damage
to the valve function and the inlet will leak water.
4-Valve Position and Routing Information:
White Handle: Receives water from water inlet on the front of the panel
Sideways: Water goes to pump inlet
Down: Water goes into the blue handled diverter
Blue Handle: Receives water from the white handle valve/water inlet on the front of the
panel
Sideways: Water goes to fixtures (cold)
Down: Water will go to or come from the fresh water tank
Green Handle: Is an on/off flow through valve that feeds pump from the fresh water tank
Sideways: Water will not flow through the valve
Up: Water will go to or come from the fresh water tank
Red Handle: Receives water from the cold water supply line
Sideways: Water goes to the hot water fixtures without going through the hot water heater
Up: Water goes to the hot water heater
City Water (Pressurized fresh water source)
1.
Connect the fresh water hose to the CITY WATER inlet.
2.
Set the color coded valves to the CITY WATER setting:
Blue handle pointing left
White handle pointing down
Red handle pointing up
Green handle pointing left
3.
Connect other end of the hose to the pressurized fresh water source.
4.
Turn ON the pressurized water source.
Water should now be available to all fixtures in the RV.
5.
To disconnect from city water, turn off water at the pressurized source first. Disconnect the
hose from the water source, (to release pressure off the system) then disconnect the hose at
the city water connection on utility center last.
Filling the Fresh Water Tank (Pressurized fresh water source)
1.
Connect the fresh water hose to the CITY WATER inlet on the utility center.
2.
Turn handles to Power FILL TANK position.
Blue handle pointing down
White handle pointing down
Red handle pointing up
Green handle pointing left
3.
Connect the other end of the hose to a pressurized fresh water source (faucet or spigot).
Turn the pressurized water source ON, the tank should begin filling.
4.
When water has reached the desired level, turn the pressurized water source OFF. DO
5.
NOT OVERFILL (tank level can be viewed on the monitor panel inside the RV).
Disconnect water source from the spigot/faucet first, then disconnect from the city wa-
6.
ter fill inlet on the utility center.
108
Table of Contents
Advertisement
Table of Contents
