Table of Contents
Advertisement
3
4
1
Fig. Engine compartment right side
1. Drain hose
2. Drain plug
3. Filler cap
4. Oil filter
90
Engine oil and oil filter - Change
Run the engine until it is warm before draining the oil .
2
Set a container which can hold at least 8 liters (2 gal)
under the drain plug (2).
Undo the oil filler cap (3), and undo the drain plug (2)
in the end of the drain hose (1). Let all the engine oil
flow out.
Remove the oil filter (4) and fit a new filter.
Collect any spillage.
Fit the drain plug (2) to the end of the hose.
Fill with fresh engine oil. See under the heading
lubricants, for the correct oil grade. Fit the filler cap (3)
and check that the oil level is correct using the dipstick.
Start the engine and allow it to idle for a few minutes.
During this time, check around the oil filter and drain
plug for leaks.
Switch off the engine, wait for a minute or so and then
check the oil level. Top up with more oil if necessary.
4812162101_D.pdf
Maintenance measures - 250 h
Switch off the engine and push in the emergency
Switch off the engine and push in the emergency
stop.
stop.
Take great care when draining fluids and oils.
Take great care when draining fluids and oils.
Wear protective gloves and goggles.
Wear protective gloves and goggles.
Deliver the drained oil to special waste handling.
Deliver the drained oil to special waste handling.
Refer to the engine manual for detailed
Refer to the engine manual for detailed
instructions when changing oil and filters.
instructions when changing oil and filters.
2021-12-14
Advertisement
Table of Contents
