Hydraulic Fluid Reservoir - Draining - Fayat Group DYNAPAC CC1300C Instruction Manual

5
6
4
Fig. Hydraulic oil filter
3. Cap
4. Filter insert
5. Handle
6. Filter holder
1
Fig. Left frame side
1. Drain plug
2021-12-14
Release the filter insert (4) from the handle (5).
Remove the filter (4) and hand in to an Remove the filter (4) and hand in to an
environment-friendly waste disposal station. This environment-friendly waste disposal station. This
3
is a disposable filter and cannot be cleaned. is a disposable filter and cannot be cleaned.
Mount the new insert on the handle, refit the unit into
the filter holder (6), and refit the red cover.
Start the engine and allow it to run at full revs for 30
seconds. Check that the filter cap (3) is tight.

Hydraulic fluid reservoir - Draining

Condensate in the hydraulic tank is drained via the
plug (1). This should be done when the roller has
stood still for some time, e.g. during the night.
Be very careful during draining. Do not drop the Be very careful during draining. Do not drop the
plug or else all the hydraulic fluid will flow out. plug or else all the hydraulic fluid will flow out.
Drain as follows:
Place a container under the plug (1). Loosen and allow
any condensate to run out. Tighten the plug.
4812162101_D.pdf
Maintenance - 2000h
117