Table of Contents
Advertisement
Figure 5-8
Installing the Perforated Shelves
[1]
Rear Pull-out Stop
[2]
Anti-tilt anchor
[3]
Front Pull-out Stop
[4]
Shelf
Figure 5-9
1. Push the shelf [4] onto the shelf support with the tilt protection devices [2] facing the rear
panel of the incubator.
2. Slightly raise the perforated shelf so that the pull-out stops [1] and [3] can slide over the
shelf support.
3. Make sure that the shelves and both of their tilt protection devices are free to move over
the shelf support.
Thermo Scientific
Shelf Support Bracket Installation
Installing the Perforated Shelves
Installation procedures
Commissioning, general
Heratherm
5-7
Advertisement
Table of Contents
