Installing Shelves; Leveling The Unit; Connecting Unit To Electrical Power - Thermo Scientific 3110 Operating And Maintenance Manual

Installing Shelves

(continued)

Leveling the Unit

Connecting Unit to
Electrical Power
Thermo Scientific
3. Install the shelf channels by placing the channel's rear slot over the
appropriate rear tab on the side duct. Pull the shelf channel forward
and engage the channel's front slot into the side duct's appropriate
forward tab. Refer to Figure 1-11.
4. Figure 1-12 shows one of the channels installed on the right side duct.
Note that if a shelf is installed in any of the bottom 3 rows of side duct
tabs that it will need to be removed to take out the humidity pan to
clean and add water.
Shelf channel
Side duct
rear slot
tab
Side duct
tab
Figure 1-11. Slot and Tab
5. The shelf can be installed with the sides up forming a tray that can be
easily removed with all of its samples, or with the sides down allowing
the samples to be carefully slid off individually. The shelf can be
partially pulled out to access samples not in the front, but be careful to
not pull the shelf out too far as there are no stops to prevent the shelf
from falling out.
Check the unit for being level by placing a bubble-style level on one of the
shelves. Turn hex nut on leveler counterclockwise to lengthen the leg, or
clockwise to shorten it. Level the unit front-to-back and left-to-right.
For electrical specifications, see the serial tag on the side of the unit,
Section 7 Specifications, or refer to the electrical schematics in Section 9
of this manual.
Warning Connect the incubator to a grounded dedicated circuit only.
The power cord connector is the mains disconnect device for the
incubator. Position the unit to allow unobstructed access to the power
cord so that it can be easily disconnected in case of an emergency.
Plug the provided power cord into the power inlet connector (Figure 1-13)
and into the grounded dedicated circuit.
Shelf channel
front slot
Figure 1-12. Channel Installed
Water Jacketed CO
Section 1
Installation and Start-Up
s
Incubator 1-9
2