Table of Contents
Advertisement
Installation
Room Ventilation
Space Requirement
For built-in units following clearances should be kept:
A, B, C and D see Operating Instructions of the unit.
E (mm/inch)
100 / 4
Installation Built-in Units
IGS
IMH/IMH-S
OGS/OMS
OGH/OGH-S
OMH/OMH-S
When installing the incubator, make sure that the installation and supply connections remain
freely accessible.
The specified side clearances represent minimum distances.
3-4
Heratherm
F (mm/inch)
G (mm/inch)
50 / 2
80 / 3.2
Clearances, as Fig. 3, without exhaust hose.
Clearances, as Fig. 3, close air port with plug, supplied with the unit.
Clearances, as Fig. 3, with additional space to operate to air slide, with air exhaust
system and exhaust hose Ø 40 mm (1.58 in)/1.5 m (59 in) (original Thermo
accessory), shortened to required length, installed according to Fig. 1 and 2.
Clearances, as Fig. 3, with air exhaust system and exhaust hose Ø 40 mm (1.58 in)/1.5
m (59 in) (original Thermo accessory), shortened to required length, installed accord-
ing to Fig. 1 and 2, operating temperature up to max. 250 °C (482 °F).
After connecting the built-in unit to the electrical
power supply, avoid damaging the power cord, then
sliding into the installation position.
H (mm/inch)
30 / 1.2
Thermo Scientific
Advertisement
Table of Contents
