Table of Contents
Advertisement
Handling and Control
Powering Up
Powering Up
1. Plug the power plug of the incubator into a suitable protection-earthed AC power outlet.
In the display window on the front panel the readiness indicator icon (rightmost icon in
the status display area at D4 in
2. Keep the On/Off button depressed for two seconds.
An initialization routine will be run after the incubator has been powered up. Once
initialization has been completed, the display will light up and the current work space
temperature will appear in the temperature display pane (item D1 in
1). The incubator is ready for use now.
Switching the Incubator Off / Powering Down
1. Keep the On/Off button depressed for two seconds.
The display window goes out, except for the readiness indicator icon (rightmost icon in
the status display area at D4 in
readout in case the work space temperature is still
switched off now.
2. If required, unplug the AC power plug to power down the incubator completely.
7-6
Heratherm
figure 7-1
on
page
7-1) is illuminated.
figure 7-1
on
page
7-1) and a residual heat temperature
≥
50 °C/122 °F. The incubator is
figure 7-1
on
page 7-
Thermo Scientific
Advertisement
Table of Contents
