Samsung S3C80M4/F80M4 User Manual page 201

S3C80M4/F80M4
IDLE MODE
Idle mode is invoked by the instruction IDLE (opcode 6FH). In idle mode, CPU operations are halted while some
peripherals remain active. During idle mode, the internal clock signal is gated away from the CPU, but all
peripherals timers remain active. Port pins retain the mode (input or output) they had at the time idle mode was
entered.
There are two ways to release idle mode:
1. Execute a reset. All system and peripheral control registers are reset to their default values and the contents
of all data registers are retained. The reset automatically selects the slow clock fxx/16 because CLKCON.4
and CLKCON.3 are cleared to '00B'. If interrupts are masked, a reset is the only way to release idle mode.
2. Activate any enabled interrupt, causing idle mode to be released. When you use an interrupt to release idle
mode, the CLKCON.4 and CLKCON.3 register values remain unchanged, and the currently selected clock
value is used. The interrupt is then serviced. When the return-from-interrupt (IRET) occurs, the instruction
immediately following the one that initiated idle mode is executed.
RESET
and POWER-DOWN
8-5