Table of Contents
Advertisement
⚫
The exhaust back pressure sensor is replaced.
⚫
The PM trap is removed or replaced.
⚫
The fuel additive nozzle is removed or replaced.
⚫
The catalytic oxidizer is removed or replaced.
⚫
The DPF regeneration MIL is on and maintenance is performed.
⚫
The DPF regeneration control module is replaced.
The operation guidelines of the DPF function are shown below:
1.
Enter the DPF menu and choose relevant models according to the vehicle being tested.
2.
Enter the DPF regeneration menu.
3.
Read carefully and complete the requisites listed before performing the DPF regeneration function. And
press OK after completing the instructions shown.
4.
Read the fuel tank level and make sure that it fulfills the requirement displayed.
5.
Read the carbon deposit load.
6.
Choose the drive to warm up and follow the instructions listed below. And press OK after completing the
instructions shown.
7.
Read the note carefully and follow the instructions shown on the screen. And press OK after completing
the instructions shown.
Figure 5-10 Sample of DPF function (screen 1)
Figure 5-11 Sample of DPF function (screen 2)
39
Advertisement
Table of Contents
