Assembly; Mounting Position; Handwheel Fitting; Actuator: Mount To Valve - AUMA SQ 14.2 Operation Instructions Manual

Assembly

4. Assembly
4.1.

Mounting position

4.2.

Handwheel fitting

4.3.

Actuator: mount to valve

12
AUMA actuators and actuator controls can be operated without restriction in any
mounting position.
Figure 6: Handwheel
[1] Spacer
[2] Input shaft
[3] Handwheel
[4] Circlip
1. If required, fit spacer [1] onto input shaft [2].
2. Slip handwheel [3] onto input shaft.
3. Secure handwheel [3] using the circlip [4] supplied.
Danger of corrosion due to damage to paint finish and condensation!
→ Touch up damage to paint finish after work on the device.
→ After mounting, connect the device immediately to electrical mains to ensure
that heater minimises condensation.
The actuator is mounted to the valve using a coupling (standard) or via lever. Separate
instructions are available for actuator mounting to the valve when equipped with
base and lever.
SQ 05.2 – SQ 14.2/SQR 05.2 – SQR 14.2
AM 01.1