Astro 360 RGBW
Control Modes
There are 5 modes:
One Astro (Auto and Manual)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the Astro is not connected with a DMX cable, it functions as a stand-alone device.
Please see pages 14-16 for more information about the Stand-alone mode and Manual mode.
One Astro (Sound-controlled)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) Turn on the music. If the device is set to sound-control, then the Astro will react to the beat of the
music. Please see page 15 for more information about the sound-control options.
Multiple Astros (Master/Slave control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Use a 3-pin XLR cable to connect the Astro.
The pins:
03) Link the units as shown in fig. 03. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on pages 14-16 (Stand-alone,
Manual or Sound-controlled mode). This means that you can set your desired operation mode on
the master device and all slave devices will react the same as the master device.
Multiple Astros (Master/Slave control)
Ordercode: 43023
• Stand-alone
• Manual
• Sound-controlled
• Master/Slave
• DMX-512 (6CH, 10CH)
01)
Earth
02)
Signal -
03)
Signal +
9
Fig. 03