Backside; Installation; Set Up And Operation - SHOWTEC Astro 360 RGBW V1 Manual

Astro 360 RGBW

Backside

Fig. 02
04) Pro power connector 100-240V IN
05) Pro power connector 100-240V OUT
06) Fuse F3AL/250V
07) Built-in microphone
08) 3-pin DMX signal connector IN
09) 3-pin DMX signal connector OUT

Installation

Remove all packing materials from the Astro 360 RGBW. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Ordercode: 43023
8