Mercedes-Benz G-Class Owner's Manual page 370

Practical advice
Flat tyre
Risk of accident
Replace damaged or corroded wheel bolts.
Never oil or grease wheel bolts.
If a wheel hub thread is damaged, you must
not drive the vehicle. Inform a qualified spe-
cialist workshop, e.g. a Mercedes-Benz
Service Centre or Service 24h.
Only use wheel bolts that are suitable for the
wheel and the vehicle. Mercedes-Benz rec-
ommends that, for safety reasons, you only
use wheel bolts that have been approved by
Mercedes-Benz. Other bolts could work
loose.
Do not tighten the wheel bolts while the ve-
hicle is raised. The vehicle could tip.
370
Lowering the vehicle
G
Open the pressure release screw of the
jack by approximately one turn using
the pump lever ( page 368).
Put the jack to one side.
P40.10-2720-31
Tighten the wheel bolts evenly in the
sequence indicated from 1 to 5.
Nur fuer internen Gebrauch
Risk of accident
Have the tightening torque checked immedi-
ately following a wheel change. The wheel
bolts may work loose if they are not tight-
ened to a tightening torque of 130 Nm.
Push the jack's piston back down and
tighten the pressure release screw.
Stow away the jack and the rest of the
vehicle tool kit.
G