Mercedes-Benz G-Class Owner's Manual page 369

P58.10-2062-31
Jack
2 Pressure release screw
Close pressure release screw 2.
To do this, turn it clockwise to the stop
using flattened end 1 of the pump le-
ver.
i
Do not turn pressure release screw 2
by more than one or two turns. Hydrau-
lic fluid could otherwise leak out.
P40.10-2719-31
Fit the jack to the axle carrier tube of
the front or rear axle. The jack must al-
ways stand vertically, even on slopes.
Raise the vehicle by pumping (arrow)
until the wheel is raised a maximum of
3 cm from the ground.
Nur fuer internen Gebrauch
Practical advice
Removing the wheel
Undo the wheel bolts.
!
Do not place wheel bolts in sand or on
a dirty surface. This could damage the
bolt and wheel hub threads.
Remove the wheel.
Fitting the wheel
Clean the wheel and wheel hub contact
surfaces.
Push the wheel onto the wheel hub and
press it on.
Screw in the wheel bolts and tighten
them finger-tight.
Flat tyre
369