Toro Groundsmaster 4000 Series Installation Instructions Manual page 11

Figure 19
1. Cab headlight bracket
2. Flange-head capscrew
(1/2 x 1 inch)
3. Headlight bracket
2. Tighten the locknut and carriage bolt.
3. Torque locknut and capscrew and locknut to 91
to 113 N∙m (67 to 83 ft-lb).
4. Route the 6-socket connector (labeled
H LH or H
EADLIGHT
wire harness through the grommet as shown in
Figure 21.
Figure 20
4. Flange locknut (1/2 inch)
5. Carriage bolt (1/4 x 5/8
inch)
6. Flange locknut (1/4 inch)
RH of the machine
EADLIGHT
1. 6-socket connector
g350620
(labeled H
EADLIGHT
H RH—machine
EADLIGHT
wire harness)
5. Remove the cap from the 6-socket connector
labeled H
labeled H
into the headlight
g350900
11
Figure 21
2. Grommet
LH or
LH or the 6-socket connector
EADLIGHT
RH, and plug the connector
EADLIGHT
(Figure 22).
g350904