Toro Groundsmaster 4000 Series Installation Instructions Manual page 13

Figure 23
1. Boot
2. Flange-head screws
2. Remove the 4 flange-head screws that secure
the steering cover to the cover mounts, and lift
the cover (Figure 23).
3. Grind a notch in the steering cover as show in
Figure 24.
Figure 24
1. Notch (steering cover)
2. 6 mm (1/4 inch)
4. Align the 12-pin connector end of the control
harness through notch in the steering cover
(Figure 25).
g350969
3. Steering cover
g350968
3. 11 mm (7/16 inch)
1. 12-pin connector (control
harness)
5. Assemble the steering cover to the cover mounts
with the 4 flange-head screws.
6. Pull the boot down and assemble the bottom of
it into the steering cover
13
Figure 25
2. Notch (steering cover)
(Figure 26).
Figure 26
g350970
g350967