Toro Groundsmaster 4000 Series Installation Instructions Manual page 22

Figure 51
1. Fuse (10 A) and fuse-block
slot A3
2. Fuse (10 A) and fuse-block
slot D4
2. Plug the horn relay into the 4-socket connector
of the machine wire harness as shown in
52.
Figure 52
1. 4-socket connector
(machine wire harness)
Installing the Electrical Cover
Machines with a Roll Bar
1. Align holes in the controller cover with clip nuts
on the electrical-component mount
g351013
3. Fuse (15 A) and fuse-block
slot A4
Figure
g350943
2. Horn relay
(Figure 53).
1. Electrical cover
2. Socket-head screw
2. Install the controller cover to the
electrical-component mount
with the 2 socket-head screws and 2 washers
that you removed in
Cover (page 21).
Installing the Electrical Cover
Machines with a Cab
1. Align holes in the controller cover with clip nuts
on the electrical-component mount
1. Electrical cover
2. Socket-head screw
2. Install the controller cover to the
electrical-component mount
with the 2 socket-head screws that you removed
in Removing the Electrical Cover (page
22
Figure 53
3. Washer
4. Clip nut
(electrical-component
mount)
(Figure 53)
Removing the Electrical
(Figure
Figure 54
3. Clip nut
(electrical-component
mount)
(Figure 54)
g351093
54).
g351092
21).