Preparing The Machine; Disconnecting The Battery - Toro Groundsmaster 4000 Series Installation Instructions Manual

1

Preparing the Machine

No Parts Required
Procedure
1. Park the machine on a level surface and lower
the cutting units.
2. Engage the parking brake.
3. Shut off the engine and remove the key.
2

Disconnecting the Battery

No Parts Required
Procedure
1. Open the battery cover on the side of the shroud
(Figure 2).
Note:
Press down on the flat surface above the
battery cover to ease the removal of the cover.
1. Battery cover
Figure 1
Figure 2
2. Press down here.
2. Disconnect the negative (black) battery cable.
1. Battery
3. Slip the rubber boot off the positive terminal, and
disconnect the cable.
g351500
3
Assembling the Headlights
to the Brackets
Parts needed for this procedure:
Right headlight—Part No. 140-6772 (light, mount,
1
washer, and nut)
Left headlight—Part No. 140-6773 (light, mount,
1
washer, and nut)
1 Left light mount (Groundsmaster 4000 Machines)
1 Right light mount (Groundsmaster 4000 Machines)
1 Left light mount (Groundsmaster 4100 Machines)
1 Right light mount (Groundsmaster 4100 Machines)
1 Left light mount (machines with a cab)
1 Right light mount (machines with a cab)
Grommet (Groundsmaster 4000 Machines and
2
machines with a cab)
2 Carriage bolt (1/2 x 5/8 inch—machines with a cab)
2 Carriage bolt (1/2 x 5/8 inch—machines with a cab)
2 Carriage bolt (1/4 x 5/8 inch—machines with a cab)
2 Flange locknut (1/4 inch—machines with a cab)
2 Cable tie
g020758
5
Figure 3
g020451