Toro Groundsmaster 4000 Series Installation Instructions Manual page 21

8
Installing the Fuses and
Horn Relay
Parts needed for this procedure:
2 Fuse (10 A)
1 Fuse (15 A)
1 Relay
Removing the Electrical Cover
Machines with a Roll Bar
At the floor along right side of the operator's seat,
remove the 2 socket-head screws and 2 washers that
secure the controller cover to the electrical-component
mount, and remove the cover
Figure 49
1. Electrical cover
2. Socket-head screw
(Figure 49).
g351012
g351093
3. Washer
4. Clip nut
(electrical-component
mount)
Removing the Electrical Cover
Machines with a Cab
At the floor along right side of the operator's seat,
remove the 2 socket-head screws that secure the
controller cover to the electrical-component mount,
and remove the cover
1. Electrical cover
2. Socket-head screw
Inserting the Fuses and Relay
1. Insert the fuses
fuse-block slots:
Fuse Rating
10 A
15 A
10 A
21
(Figure 50).
Figure 50
3. Clip nut
(electrical-component
mount)
(Figure 51) into the following
Fuse-Block Slot
A3
A4
D4
g351105
g351092