Toro Groundsmaster 4000 Series Installation Instructions Manual page 17

Installing the Switch Plate to the
Steering Column
1. Align the switch plate to the rearward side or the
steering column (Figure
Figure 36
1. Carriage bolt (1/4 x 2
inches)
2. At the upper 6.4 mm (1/4 inch) holes, assemble
2 carriage bolts bolt (1/4 x 2 inches) through the
switch plate and the other bracket mount
36).
3. Assemble the fuse mount plate to the upper
bracket mount and carriage bolts
with 2 flange locknuts (1/4 inch).
37).
g350762
2. Bracket mount
(Figure
(Figure 37)
1. Bracket mount
2. Carriage bolt (1/4 x 2
inches)
3. Switch mount
4. At the lower 6.4 mm (1/4 inch) holes, assemble
2 carriage bolts bolt (1/4 x 2 inches) through the
switch plate, bracket mount, and fuse mount
plate (Figure 37) with 2 carriage bolts (1/4 x 2
inches) and 2 flange locknuts (1/4 inch).
5. Align the switch plate to the operator's seat, and
tighten the 4 flange locknuts.
Connecting the Console Harness
to the Switches
1. Plug the 8-socket connector of the control
harness labeled H
connector of the rocker switch
1. 8-pin connector (rocker
switch)
17
Figure 37
4. Fuse mount plate
5. Flange locknut (1/4 inch)
S into the 8-pin
AZARD WITCH
(Figure 38).
Figure 38
2. 8-socket connector
(labeled H
AZARD
S —console
WITCH
harness)
g350772
g350776