EMAK K 700 H Workshop Manual page 54

Connecting rod big end oil clearance (radial)
1) Clean all oil from the crankshaft neck journal and inside side.
2) Place a piece of plastic gauge on the crankshaft neck journal,
assemble connecting rod, and tighten the bolts to specified
torque.
Bolt torque: 14 Nm
Do not rotate the crankshaft while the tightening
connecting rod bolt.
3) Remove the connecting rod and measure the plastic gauge.
Standard
0.040 mm ~ 0.063 mm
4) If the clearance exceeds the service limit, replace the
connecting rod and recheck the clearance. After using new
connecting rod, the clearance still exceeds the service limit, lap
the neck journal and use a connecting rod lower than standard
value.
Camshaft cam height
Standard
IN 27.70 mm
EX 27.75 mm
Camshaft OD
Standard
13.984 mm
Note
Note the location of the decompression mechanism, check
to be sure it moves freely.
Camshaft axletree ID
Standard
14.0 mm
Service limit
0.12 mm
Service limit
Replace under 27.45 mm
Replace under 27.50 mm
Service limit
13.916 mm
Service limit
14.048 mm
54
Workshop manual
14 Nm
Plastic gauge scale