EMAK K 700 H Workshop Manual page 34

b Disassembly / Reassembly
Note
Clean the carburetor before
reassembly.
Carburetor body
Reassembly: Check the screw head
for wear or damage before installing.
Pilot screw
Reassembly: Check the screw head
for wear or damage before installing.
Main nozzle
Reassembly: Clean
thoroughly with
compressed air before
assembly.
Main jet
Reassembly: Clean
thoroughly with
compressed air before
assembly.
Float
Reassembly: Check for smooth
movement by finger after installation.
Float chamber
Main nozzle
Assembly: Clean with compressed
air and lightly lubricate O-ring
before assembling.
Fuel valve lever
Spring Needle Valve
Float pin
Set bolt
Check for
installation.
34
Workshop manual
O-ring
Choke lever
Float valve
Assembly: Assemble after checking for
float seat, float valve and float valve
spring wearing.
Float valve seat
Float valve
OK
O-ring
Reassembly: Check whether it is
correctly installed in the groove.
Fuel drain bolt
Check for fuel leakage
installation.
fuel leakage after
REPLACE
after