EMAK K 700 H Workshop Manual page 35

Workshop manual
c Disassembly / Reassembly
Place the carburetor as shown on the drawing. Measure
the distance between the float top and carburetor body
when the float just contacts the float valve.
Standard height
If the float height is not within specification, replace float
valve and recheck the float height
Washing carburetor
Warning
In order to avoid injury, please wear safety
eyeglasses or other eye protector when using
compressed air.
Attention
Some chemical solvent has strong causticity
which can damage plastic parts, such as, O-ring,
and float valve seat. Please carefully read vessel
manual. If you don't affirm, don't use this solvent
to wash carburetor. Too maximum air pressure can
damage carburetor, please use proper pressure to
wash passage and tube mouth.
1) Use detergent to wash the carburetor.
2) Use low pressure air to clean passage, air hole,
assistant screw hole, assistant jet hole, assistant air jet
hole, main air jet hole and assistant hole.
Note
The carburetor has inner through and outer
through air holes. For outer through hole, it passes
through to carburetor oil cup, as well as inner
through air hole is closed. For inner through hole,
it passes through to carburetor oil cup, as well as
outer through air hole is closed.
13.7 mm
Engine side
Air cleaner side
Assistant
jet
Main jet scat
35
Float level gauge
Outer through air
Conversion hole
Assistant hole
Outer through
air hole
Assistant jet
Main jet