EMAK K 700 H Workshop Manual page 49

Workshop manual
Crankshaft bearing
Assembly：Assemble the bearing in with following the tool
after applying engine oil.
Assembly lever 52×55 mm outer retainer assembler
Assistant assembler
Gear on the crankshaft
Disassembly：
Mark a line on the crankshaft and a timing gear. Set the
commercial available bearing puller plate on the lower part
to the governor drive gear and remove the crankshaft and
timing gear by manual compressor.
Disassemble the governor drive gear in the same way.
Assembly：
Timing gear
Using the old gear for reference, make a mark at the same
position on the new gear. Using a hydraulic press, lever and
inner retainer assembler (the special tools shown,), press
the timing gear onto the crankshaft after aligning old and new
gears mark flush.
Governor drive gear
Use a hydraulic press lever and inner retainer assembler
(special tool) to press in a new governor drive gear.
Lever
49
Inner retainer
assembler
Assistant assembler
Lever
Inner retainer assembler
Lever
Inner retainer assembler