Governor; Fuel Filter - EMAK K 700 H Workshop Manual

Workshop manual

3.9 Governor

1) Take down the fuel tank.
2) Loosen the nut on the governor arm pinch bolt.
3) Move the arm until the throttle is completely
open, and hold it in that position.
4) Rotate the governor arm shaft as far as it will go
in same direction it was just moved by the
governor arm, and then tighten the governor
arm pinch bolt.
5) Whether check the arm and throttle move
smoothing.
6) Install the fuel tank.
7) Start the engine and adjust the limiting screw to
produce the standard until the engine warm up
to normal operating temperature.

3.10 Fuel filter

Warning
Gasoline is extremely flammable and explosive. Don't
smoke and fire on the working site. Don't allow the
gasoline overflowing.
1) Drain the fuel in the fuel tank thoroughly out and remove the
fuel tank.
2) Remove the fuel tube, and remove filter from the fuel tank.
3) Wash the filter with solvent and check strainer if there is
damaged, put the O-ring on the filter, reassemble the filter
and tighten to specified: 2 Nm.
4) After that, check if there is leaking.
Governor spring
Throttle
Limiting screw
21
Governor arm
pinch bolt
Governor arm
Anti-surge spring
Outlet fuel
Fuel tube
Nut
Governor
arm shaft
Fuel cap
Filter fuel
Fuel tank