EMAK K 700 H Workshop Manual page 53

Workshop manual
Inspection of connecting rod
Replace the connecting rod if it's bent, warped, or its big end cap or the outer race of its small end's shaft
sleeve is loose, or any of its end has cracks.
Connecting rod small end ID
Replace the connecting rod if its small end I.D. is smaller than
standard value or is out of service limit.
Model
K 700 H – K 800 H
Crankshaft pin OD
Replace the connecting if its big end I.D. is smaller than standard
value or is out of service limit.
Standard
30.22 mm
Crankshaft pin OD
Standard
30.16 mm
Crankshaft pin OD
Standard
0.10 mm ~ 0.70 mm
Standard
13.005 mm
Service limit
30.246 mm
Service limit
30.1 mm
Service limit
1.1 mm
Service limit
13.07 mm
53