Cylinder Head, Valves - EMAK K 700 H Workshop Manual

c Spark plug cap
Put the tester to contact the two end of the spark plug cap and
measure spark plug cap resistance.
Resistance
If the resistance is out of the specification, replace the spark plug.
Adjustment
Adjustment is required only when the ignition coil or the flywheel has been removed.
1. Loosen the ignition coil mounting bolts.
2. Insert the thickness gauge or a piece of paper of the proper thickness between the ignition coil and the
flywheel, both gaps should be adjusted simultaneously. Avoid the magnet when adjusting the air gap.
3. Push the ignition coil firmly toward the flywheel and tighten the mounting bolts.
Specified clearance

5.2.7. Cylinder head, Valves

Disassembly / reassembly
Bolt: M6 x 14 (4)
Torque: 8 ~ 12 Nm
Gasket
Cylinder head cover
Bolt: M8 x 60 (4)
Torque: 32 ~ 35 Nm
Removal / installation: Loosen
and tighten the bolts in a
crisscross pattern in 2-3
7.5 – 12.5 KΩ
0.20-0.60 mm
(0.008-0.020 in)
Spark plug
Reassembly: Clean and adjust
spark plug before installation.
steps.
Cylinder pad
Cylinder head
 Remove carbon deposits from the

Shroud
42
Workshop manual
Spark plug cap
Pin (2)
combustion chamber and check
the valve seat before assembling.
Measure the cylinder
after assembling.
pressure